|
|
The Challenger Filter
The CHALLENGER line of
filters, the most definitive statement in filtration
design, this filter is one dependable piece of
equipment. With fiberglass construction and
MULTI-PORT valve you have a very efficient bead
filter with a 10 years warranty. This filter is very
easy to service, with a side mount multi-port valve you
won't have to undo any plumbing to access the internals
of the filter.
The CHALLENGER series utilizes the
HYDRA-THRUST bead agitation system. Air is forced
into the vessel to thoroughly agitate the beads and
break free the entrapped debris. The pump then gives a
thorough backwash and rinse via the multi-port valve.
You will enjoy the longer intervals between backwashing
with these large diameter filters.
|
|
A couple of the
advancements have been made to the popular Challenger
line of filters is the addition of the Hydraswirl
technology and Sludge drains. With the Hydraswirl
addition solids are spun to the center of the vessel where they
wait for the operator to open the sludge drain. With this unique
feature, solids are purged under pressure, while opening the
Sludge drain with the pump running. This forces the heavier
solids out of the filter to waste in a matter of a few seconds.
A Multiport Valve is provided as standard equipment with
features such as Backwash, Rinse, Recirculate, and more.
The Challenger Filter
is available in 5 sizes to meet your pond requirements.
|
Model |
Size of Pond |
Price |
|
Challenger #40 (1.75 cu. ft.) |
up to 2500 gal |
Call for Price: |
|
Challenger #50 (2.50 cu. ft.) |
up to 5000 gal |
Call for Price: |
|
Challenger #60 (4.25 cu. ft.) |
up to 10,000 gal |
Call for Price: |
|
Challenger #100 (6.00 cu. ft.) |
up to 15,000 gal |
Call for Price: |
|
Challenger #140 (9.00 cu. ft.) |
up to 22,000 gal |
Call for Price: |
A 1hp Air Blower is included
with all Challenger models
Introducing the Water Miser Drain.
The Water Miser Drain comes standard on the Challenger
filter making a near perfect filter even better. The
Water Miser drain allows an Ultra low volume backwash if
water is expensive, in short supply, or you have a low
volume heavily stocked pond.
|
 
Challenger Cutaway |
|
BENEFITS AND FEATURES:
- Sturdy fiberglass
construction.
- Available to fit most
any size pond.
- Constructed with
minimal flow restriction in mind.
- All plumbing is 2
inch.
- Easy hydraulic back
wash with no dirty discharge to the pond.
- Now available with a
sludge removal feature on the bottom of the filter.
- Small footprint -
Ideal for space limited situations.
- Easy installation.
- 500-550 cubic feet of
surface area per square ft of media.
- Hydra-thrust Blower
is included with every filter to assist with backwashing.
- Sludge removal drain
on the bottom of each Challenger assures full removal of
waste with each backwash.
- The New Hydra Swirl
feature allows uniform distribution of flow and debris
throughout the filters bead pack.
- A Multiport valve is
provided as standard equipment with features such as
Backwash, Rinse, Recirculate, and more.
|
[ Home ] [ Up ]
Contact us for further details. |
